How Do I Make A Roof Rake

Rake plates of one by 2 inches often cover the exposed top edge of the liner when there is also a ledge at the end of the gable.

How do i make a roof rake.

Position a bracket on each side of the. I used the driveway sealer squeegee and an extension pole to work as a snow roof rake. When the snow started to pile up on handyman bill. On the 1 x 12 arms where you placed the marks in the previous step use the hole saw to bore straight through.

Make sure the holes on the brackets are lined up and are angled at 90 degrees. Insert your 2 1 2 inch. Apply some pvc glue to the inside of the arms. Measure and place a mark 2 from an end.

I have to say it worked great i used the metal part face down not the rubber part. An added bonus was that i could use one end of. Drill straight through the aluminum handle through one bracket hole to the hole on the other side using your. Attach the two 4 inch angle brackets to the end of your aluminum pole.

Begin by cutting two 12 sections from one on the 1 x 10 pvc pipes. The roof rake plates are installed in different widths depending on the surface being covered. Use your clamp to attach the two 4 inch brackets to one end of the aluminum pole positioning one angled bracket on each side. Use the drill to make a hole in the aluminum pole using the bracket holes as a guide.

How to make a roof rake step 1. Here s what i came up with.