The patch should be larger than the piece you removed.
How do i glue a patch to vinyl siding.
Cut a vinyl patch 4 inches 10 cm wider than the removed segment.
Then lock the siding back into place.
Cutting the tip at.
Use a table saw or circular saw to cut a patch from a good piece of vinyl.
Place foil tape on the back side of the siding to cover the hole and lock the siding back in place.
Clean the siding around the hole with vinyl siding cleaner or mild dish detergent and water and a soft sponge.
Measure and mark a point 2 inches 5 1 cm away from each side of the removed segment.
Cut the nozzle tip on a tube of color matched vinyl siding caulk with a utility knife and fit the caulk into a caulk gun.
It ll better match the house than brand new siding.
Hold the removed segment up to a spare piece of vinyl siding.
Use painter s tape to hold the piece in place while the glue dries.
Use tin snips to cut out the damaged area image 1.
Cut the spare piece of vinyl along the marks using straight tin snips.
Wipe the siding dry with a rag.
Run a bead of adhesive caulk around the back of the patch and set the patch in place top image.
Fill the hole with a thin coat of color matched caulking or paint the caulking to match the siding color as described above.
Remove the tape once the glue has dried.
Avoid allowing the epoxy to leak through any hole or crack.
Mix the two part epoxy according to the manufacturer s directions.
In this video this old house general contractor tom silva explains how to repair vinyl siding.
Use framing square and utility knife to cut through face of siding.
Position the patch and glue it on with the polyurethane adhesive construction glue.
You can patch a hole in your vinyl siding in less than three minutes using tear aid type b from.
Cut off any overhanging vinyl.
Step 4 place a full length piece on the corner.
